Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

DIN 5480 shaft motor and hub fitting

Thread starter Comeau
Start date Apr 29, 2008

Status: Not open for further replies.

Apr 29, 2008

Comeau

Mechanical

I have an hydraulic motor with shaft DIN 5480 W40x2x30x18x9g. I must make a hub that fit this shaft. I don't know exactly the specification I must give to the guy that will make the hub? Do N40x2x30x18x9H will be OK? I know that there is different tolerance class but don't know which to choose. What must I know to do the best choice? Do I must absolutely know the addendum modification of the shaft or this value is calculated with the W40x2... I don't have much experience with gear. Thank you for your help.