Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

DIN STANDARDS

Status
Not open for further replies.

Rich01

Mechanical
Apr 23, 2001
3
CA
Anybody can tell me if there is a DIN standard for hot rolled steel bar products (round or square) that exists beside DIN-1014-1 and DIN-1014-2?

the tolerances I'm looking for in these products is a plus or minus 0.25mm on side lenght deviation.

Thanks.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top