Disappearing Detail View... 2

[Nella95]

So I have a detail view that won't stay displayed. Usually when this happens, I change the view state from 'Hidden Lines Visible' to 'Shaded With Edges' - or vice versa. I do this once and it never gives me trouble in that session again.

This time though my little trick doesn't work. It's like the view is hidden 'behind' something - but it's not.

Any thoughts?

Thanks in advance.

SW Professional 2015 SP 5.0
SW Electrical 2D/3D SP 5.0
64 bit
Intel Xeon X(R) CPU 3600 @ 2.80 GHz
8.0 GB of RAM
NVIDIA Quadro 2000

 

[Nella95]

This is crazy. I have the exact same view on two other Sheets - no problems at all.

(I guess I can re-do the entire drawing.)

SW Professional 2015 SP 5.0
SW Electrical 2D/3D SP 5.0
64 bit
Intel Xeon X(R) CPU 3600 @ 2.80 GHz
8.0 GB of RAM
NVIDIA Quadro 2000

 

[felix7502]

Have you tried Rt. Click, View, Reset Sketch Visibility? This usually works for me. You have to click in the view area though.

 

[Nella95]

Didn't try that. Thanks, but that didn't work - however it prints out just fine. ??!?!

This has to be 'operator error' - I'm sure of it, I just don't want to re-do the drawing.

SW Professional 2015 SP 5.0
SW Electrical 2D/3D SP 5.0
64 bit
Intel Xeon X(R) CPU 3600 @ 2.80 GHz
8.0 GB of RAM
NVIDIA Quadro 2000

 

[samuelm]

Nella95,

I can't say for certain but this problem seems familiar for some reason. I recall my fix was delete view then do an undo delete.

Hope this helps.

Regards,

Samuel