Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Display data asked for shadow of unloaded entity

Status
Not open for further replies.

jimchest

Mechanical
Feb 19, 2003
14
thread561-395552. Same problem as closed thread that was never replied to. It seems to be a problem with PMI. Cannot get back from the model to the parent drawing. the error "Display data asked for shadow of unloaded entity" STOPS me from making the drawing the work part
 
Replies continue below

Recommended for you

The description is a bit thin to go on.
I have never seen this error.
It sounds as if something in the file requires more data to be loaded. ( not sufficient with what's loaded in the session.)
Can you make the assy fully loaded ?
Maybe you should speak to Gtac about this.


Regards,
Tomas


 
In context of PMI there is an existing IR9004419 for a similar problem (don't know if it is the same for you)

GTAC said:
Problem Description:
Use "Convert to PMI" in the drafting application.
The user switch the "Make Work Part" on the modeling application, an error will occur.
"Display data asked for shadow of unloaded entity" error occurs.

The cause of the error is that "PMI" in "Part Navigator" is in the expanded state.
If the "PMI" is collapsed, no error occurs.

It shows no solution or workaround however.


Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX11 / TC11
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor