Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Display of assembly cut in part.

Thread starter silverunner
Start date Jul 8, 2004

Status: Not open for further replies.

Jul 8, 2004

silverunner

Aerospace

Hello All,
I was just wondering if this is possible. I have a hole in the assembly that cuts through some parts. When I open any of the affected parts, the hole is there. Is there a way to remove the hole from the part withough affecting the assembly? This could be usefull for machining purposes.
Thanks
MK