Display option for load/constraint symbols 1

[cnuk]

Probably a simple question, but for a newcomer it's still confusing.

I want to display all of the symbols for loads, constraints, etc ALL THE TIME. When I apply a constraint, I see the symbols showing it has been created. After doing a few more operations those symbols disappear. I would like them to always be visible. I'm sure for large models it could get messy but my models are so simple while learning it would be very helpful. I assume there is some kind of display option but the help file has turned up nothing so far.

Thank You

 

[Drej]

PlotCtrls --> Symbols... --> "All Applied BCs" --> OK

If you've applied the BCs to geometry, issue SBCTRAN to transfer them from the geometry to the FE model.

-- drej --

 

[cnuk]

Thanks. I did have BC's applied to geometry and SBCTRAN did the trick.

Thank you for your patience with a new user....greatly appreciated!!