Display slab design reinforcement

[shijie0411]

Hi everyone,
In Safe version 12, can we show slab design reinforcement (strip based) together with our defined strip and width? I found even if I already set display options as strip layer and strip width on, when I go to DISPLAY- SHOW SLAB DESIGN, the strip can not be shown on the page. That is so not convenient to find out reinforcement for each individual design strip, especially for complicated framing plan.
Thank you.

 

[johnbridge231]

I would suggest you not to use strips, as they can only apply to simplified slabs regarding their geometry.

Analysis and Design of arbitrary cross sections
Reinforcement design to all major codes
Moment Curvature analysis

http://www.engissol.com/cross-section-analysis-design.html