Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Distortions of view inside the workbench during sketching 1

Status
Not open for further replies.
ayfatt14

ayfatt14

Automotive
Nov 15, 2020
3
0
0
MA
Dear

When i enter to workbench for sketching by selecting a one of the three axies , i found a problem like Distortions of view of the part design
k%C3%A8%C3%A8%C3%A877_drjt5k.jpg


How i can solve this problem to make any part looking straight in lines inside workbench


Thank you before
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

Bombas
  • Locked
  • Question
msgcatalog - name changes of front view e.t.c.
Replies
2
Views
20
Bombas
Bombas
Mirme.lee
  • Locked
  • Question
How to activate the sheet to which the selected view belongs?
Replies
3
Views
25
Mirme.lee
Mirme.lee
M1nh
  • Locked
  • Question
How to get the View from Capture Support via VBA ?
Replies
0
Views
28
M1nh
M1nh
sri91
  • Locked
  • Question
Leader target as view
Replies
0
Views
12
sri91
sri91
BasicEngineer
  • Locked
  • Question
Automated Detailed View Generation - VBA
Replies
1
Views
20
Little Cthulhu
Little Cthulhu
Back
Top