Does Ansys have capibilities to generate a mesh like the picture? 2

[aminjamali]

Hi,

I was wondering if Ansys has the capabilities of generating a mesh like the picture I have attached? I know that it is possible in ABAQUS.
A very awkward approach would be meshing individual areas with uniform mesh, and then constrain them together. I wonder if there is any better approach? I appreciate your helpful tips very much.

 

[Stringmaker]

Your picture didn't come through. In general though, Ansys can generate a very high quality mesh given decent geometry and a knowledgeable user.

 

[aminjamali]

I attached the picture again. Please take a look at it.

 

[jiligeo]

Hi Amin, you can do that with Ansys. Please look to:
“Creation of Transitional Pyramid Elements at an Interface”, in Ansys manual.

Regards
Jalil

 

[jiligeo]

and also

7.4.2.2.2. Transition Mapped Hexahedral Meshing

 

[meshparts]

and also by refining the original mesh in 2 steps, see erefine.

Alex

 

[aminjamali]

Thanks you all, I am gonna give it a try