Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Does anybody know how to use MATRIX27 in workbench?

Thread starter Shkara
Start date Jul 8, 2015

Status: Not open for further replies.

Jul 8, 2015

Shkara

Mechanical

Dear All, I have a wind turbine blade and I would like to reduce the blade to an equivalent beam in workbench, I have the stiffness of the blade along the span, so I think MATRIX27 element type suits this purpose but I don’t know how to do that? Can anybody tell me how to deal with this in workbench?