Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Does anyone use Netmeeting 3.0 on XP64 - need help.

Status
Not open for further replies.
texaspete

texaspete

Mechanical
Nov 11, 2002
120
Hi gang, it's me texaspete again, sorry I haven't written in a while. I have a problem. I have a Dell 470 with Xp64 and I would like to do some web collaboration with some remote customers. PTC says they no longer support pro/collaboration. I had this capabilities using Windows 2000 32bit system; but I don't where it is on XP64. Can anyone give me some step-by-step instructions on locating program, setup to host web collaboration session and tell me what the customer needs to do as a client.
Thanks in Advance - Texaspete
 
Status
Not open for further replies.

Similar threads

dkakth
  • Locked
  • Question
dependency on import ? 1
Replies
1
Views
144
3DDave
3DDave
kaengo
  • Locked
  • Question
Problems with Creo 3.0 Graphics
Replies
0
Views
106
kaengo
kaengo
shanemolloy
  • Locked
  • Question
Replacing a component in an assembly based on excel
Replies
0
Views
156
shanemolloy
shanemolloy
DesEngineer4
  • Locked
  • Question
Need Suggestions on CAD data management without PLM
Replies
10
Views
221
3DDave
3DDave
Windchill Creo
  • Locked
  • Question
Need to check the state of parts in Windchill(Creo) 1
Replies
12
Views
283
looslib
looslib

Part and Inventory Search

Sponsor

Back
Top Bottom