rpoling
Industrial
- Jan 17, 2003
- 1
Using Inventor Series 6...
Sometimes when in sketch mode, it won't recognize a line for projecting or for dimensioning to it. Its as if its not there. It will recognize points, arcs, circles, just not lines. Once it gets in this "mode", it stays like that for that part. Grrrrrrrrrrrr........
Any ideas what's gong on? It makes constrining things impossible!
Sometimes when in sketch mode, it won't recognize a line for projecting or for dimensioning to it. Its as if its not there. It will recognize points, arcs, circles, just not lines. Once it gets in this "mode", it stays like that for that part. Grrrrrrrrrrrr........
Any ideas what's gong on? It makes constrining things impossible!