Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Doing research

Thread starter Scorch
Start date Feb 15, 2007

Status: Not open for further replies.

Feb 15, 2007

Scorch

Mechanical

I have been asked to do a little research to see if Visio plays nice with Pro/e. We are going to be changing over to Pro/e from Solidworks in a about a month and they want to know if you can embed a Visio file into a drawing in Pro/e like you can in Solidworks. I can not find any information on this at all. Any help would be appreciated.

Thanks

Don't worry about people stealing your ideas. If your ideas are any good, you'll have to ram them down people's throats.
--Howard Aiken, IBM engineer