cadcougar
Mechanical
- Dec 19, 2007
- 1
Looking for a chart of standard industry dovetail dimensions (male and female).
Trying to match the dovetails on an existing machine (depth = 1-inch (female) and 15/16-inch (male), width across the tail tips is approximately 4-inch, dove tail angle is 60 degrees.
The dove tail uses a side take-up gib and bearing is on the plain below the male dovetail. Dovetail is measured using (2) pins as described in the machinerys handbook (see prior post).
CadCougar
Trying to match the dovetails on an existing machine (depth = 1-inch (female) and 15/16-inch (male), width across the tail tips is approximately 4-inch, dove tail angle is 60 degrees.
The dove tail uses a side take-up gib and bearing is on the plain below the male dovetail. Dovetail is measured using (2) pins as described in the machinerys handbook (see prior post).
CadCougar