Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dr. Vogel's Sparbeize

Status
Not open for further replies.
CalvinKelly

CalvinKelly

Materials
May 12, 2003
33
Does anyone know where an American might be able to purchase this aid to metallography? European stainless mills use it in their labs but the source is a secret to those of us on this side of the Atlantic

James Kelly
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

Taoufik Sbai
  • Locked
  • Question
Galvanized surfaces : Dross acceptance criteria
Replies
1
Views
96
Taoufik Sbai
Taoufik Sbai
PS.Material
  • Locked
  • Question
Application of WB 384 1.8807 as Boiler Drum Material in ASME Section I
Replies
2
Views
166
MJCronin
MJCronin
tl-sign
  • Locked
  • Question
Drawing notes for surface condition after heat treating 17-4 PH 1
Replies
1
Views
144
mfgenggear
mfgenggear
Laboratorio TRF
  • Locked
  • Question
Out-of-range ultimate tensile strength (UTS) of a cold-drawn 304 tube.
Replies
4
Views
50
Laboratorio TRF
Laboratorio TRF
jszymkowski
  • Locked
  • Question
Example of drawing identifying cut plane for examination of internal porosity in an aluminum casting
Replies
0
Views
48
jszymkowski
jszymkowski

Part and Inventory Search

Sponsor

Back
Top Bottom