Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

DRADER INJECTIWELD for HDPE welding 1

Status
Not open for further replies.
Ingenuity

Ingenuity

Structural
May 17, 2001
2,347
0
36
US
Has any one used or have experience with this DRADER INJECTIWELD plastic welding unit?

Link

My application is 2.0mm thick HDPE tubing of 16mm diamater where I wish to weld a longitudinal seam.


 
Replies continue below

Recommended for you

Sort by date Sort by votes
You might consider sending them a sample and asking them to perform a weld on it to demonstrate their machine's capability.

It is better to have enough ideas for some of them to be wrong, than to be always right by having no ideas at all.
 
Upvote 0 Downvote
By way of follow-up, I sent a sample to one of the manufacturer's resellers and they conducted a trial weld and returned the sample to me:

image_qomlpj.jpg
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Bioguy24
  • Locked
  • Question
HDPE storage and processing quality
Replies
1
Views
20
Compositepro
Compositepro
IoannisP
  • Locked
  • Question
HDPE bags in roll problem
Replies
0
Views
12
IoannisP
IoannisP
Buckshott00
  • Locked
  • Question
Process Setting for Improved Over-molding to prevent delamination In Molded / Extruded Hytrel
Replies
0
Views
20
Buckshott00
Buckshott00
Tymon
  • Locked
  • Question
Most suitable laminating adhesive film for TPU lamination
Replies
0
Views
14
Tymon
Tymon
andradesilva
  • Locked
  • Question
Silicone rubber, material properties for stability (damped vibration)
Replies
1
Views
21
IRstuff
IRstuff
Back
Top