Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
drafting dimension style = 7'-5 1/2"
- Thread starter vinkez
- Start date
Kevin,
Is it differant than v5r7 in that you change the standard in the "dimention properties" window to "FEET-INC" ?
Even this still creates the dimension as 7' 5.50". And the only way I've been able to get 7' 5 1/2" is to select the dimentions individually and change the properties under "Value/Format" to fractional.
bob
Is it differant than v5r7 in that you change the standard in the "dimention properties" window to "FEET-INC" ?
Even this still creates the dimension as 7' 5.50". And the only way I've been able to get 7' 5 1/2" is to select the dimentions individually and change the properties under "Value/Format" to fractional.
bob
- Status
