Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

DraftSight Breakline Symbol?

Thread starter melitza03
Start date Mar 28, 2016

Status: Not open for further replies.

Mar 28, 2016

melitza03

Industrial

I saw a closed thread on this topic, but no response was posted on it.

Is there a way to make a breakline on a dimensional callout in DraftSight? The prompt in AutoCAD is dimjogline. It shows the dimension as being longer than represented by the general scale of the drawing.