Dragging dimensions and sketched entities in 2005

[cmm]

I just upgraded from 2004 to 2005SP0.1. Now when I drag dimensions and sketched entities they don't move with my pointer. They drop where I release the mouse button, but I need to see the motion in between. Is there a setting I need to change?

Chris Montgomery
Mechanical Engineer

http://www.adaptivequipment.com

 

[SBaugh]

I guess i don't follow your question because i just tried the same thing in both SW04 and SW05 and I don't see a problem with either. They both behave the same way.

With the text hides, but a box appears around where the text was when I drag it.

And I get dynamic preview of the line when I drag it.

Regards,

Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376
faq559-716 - SW Fora Users

 

[cmm]

I rebooted and the problem went away. Ahhh software.

Chris Montgomery
Mechanical Engineer

 

[CorBlimeyLimey]

Check your Graphics card driver & make sure it's SW certified for SW2005.

& all the best.