Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drawing Number Scheme

Status
Not open for further replies.

frankreid

Mechanical
Mar 9, 2007
92

A customer has asked me to suggest a scheme for new drawing numbers. He would like it to have seven digits with the first character a letter, plus a two-digit dash number.
Any Ideas?
Thanks

Frank Reid
Reid Engineering Services of Utah
 
Replies continue below

Recommended for you

Similar comes up over in forum781 every now and then.

General consensus seems that for most folks avoiding 'intelligent' part numbers is beneficial.

Posting guidelines faq731-376 (probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484
 
What does the first character represent, if anything?

The best numbering system is non-intelligent, sequential numbers. The length is up to you. The use of dash numbers is no problem, just define when you use dash numbers.

I have been at a company that used a unigue number for most parts. If the part was used in a weldment, then the weldment details would be given dash numbers of the unique weldment number. Dash numbered parts were never sold as spares.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor