Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drawings-is there a scale factor for line styles?

Thread starter borsht
Start date Jun 4, 2020

Status: Not open for further replies.

Jun 4, 2020

borsht

Mechanical

My line styles are way to tiny on my drawing, which is to say the hidden dashed lines are super small, which makes them just look like a dotted line ......... instead of dashes? Same with the phantoms. so is there a scale factor I need to change or is my only choice to modify the "Document Properties/Line Style/line length and spacing values"?

SolidWork Newbie since 2001
-Currently using SW2017

Inventor Newbie since 2019
-Currently using Inventor19