I am working on a preliminary geotechnical exploration in northwest Florida for possible locations for a solar pv site. Soil conditions consist of dense clayey fine sands (SC) with fines contents of 47% from the ground surface to a depth of 15 ft.
Would you run UU tests or CU (with pore pressure readings) to assign strength parameters? I'm not sure if I should look at this as an undrained loading or not due to the wind loads.
Would you run UU tests or CU (with pore pressure readings) to assign strength parameters? I'm not sure if I should look at this as an undrained loading or not due to the wind loads.
