I need to display dual dimensions on some but not all dimensions shown on a drawing. I have set my .dtl file so that I am able to display dual dimensions however it effected all dimensions shown. What's the trick to just show them on the dimensions that I need them to be on and not the others?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
dual dimension question
- Thread starter adub
- Start date
I have this set in my DTL file also and dont have that problem. In your config.pro set tol_mode to nominal. Dims should initially show as regular (single no tolerance) but you can right click and bring up the properties menu, then use the pull down tolerance menu.
MM
MM
- Status
Similar threads
- Locked
- Question