Dual Dimensioning Question

[cygnas]

When I use dual dimensions (upper & lower format) SW automatically puts the mm dimension in brackets and on top while putting the inch units on the bottom. Since inch units are our standard I would like to have them on top and the mm with the brackets on the bottom. Is there a setting to reverse this?

Thanks in advance.

 

[CorBlimeyLimey]

Under Tools > Options > Document Properties > Detailing there is an option of On top or On the right.


Making the best use of this Forum. faq559-716
How to get answers to your SW questions. faq559-1091
Helpful SW websites every user should be aware of. faq559-520

 

[cygnas]

If I use the "On the Right" option it does put the Inch dimension first. However, our company standard for dual dimension is "Top & Bottom" style. I need to use the top and bottom style with the inch dimension on top. Hopefully this can be done.

 

[CorBlimeyLimey]

Not with the standards which SW follows.


Making the best use of this Forum. faq559-716
How to get answers to your SW questions. faq559-1091
Helpful SW websites every user should be aware of. faq559-520