DXF creation using journal

[swale74]

thread561-264567

I used the above thread and the PDF conversion works flawlessly. I've also tried to use the dxf conversion to provide our customers with 2D autocad prints. Everytime I run the moog_s_export_dxf_2.vb file I get a (Journal)"Error occurred in new file creation The selected template doesn't exist journal exiting" Is this a missing license or is one of the string paths need to be adjusted?

 

[jerry1423]

If you create a dxf without recording a journal, do you get an error?

 

[cowski]

That particular journal was modified for moog's environment, where the 'blank' template was not available. Try the one attached to this post, which is just a slightly updated version from the original thread: thread561-264399

 

[swale74]

Worked perfectly cowski, Thanks for your help. This will help out alot.