Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dynamic Sectioning

Status
Not open for further replies.

magnam

Automotive
Sep 19, 2009
3
I saw earlier post from 2006. It is now 2009. Has Pro E Wildfire either Ver4 or 5 come up with Dynamic Sectioning similar to Catia V5?
 
Replies continue below

Recommended for you

I think you mean this...

View>
Display Settings>
Visibilities>

Adjust the top slider to ajust clipping percentage on the model.

Adrian
 
Try eDrawings which should allow a more user friendly method to do so. With the dynamic updates in WF5 this might be possible by dynamically modifying an offset plane or possibly view manager redefine but I've not tried that.

Michael
 
Thank You all for the replies. Yes I did try the view display settings clipping method but the clip is just normal to the screen. I was looking for a way to set the clipping plane say on a 'X' plane for example and slide it rearward in the 'X' direction while in an isometric view 3d view. It would also work in the 'Y' and 'Z' directions as well as setting it up normal to any line and sliding it back and forth.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor