Hi.
Im try to do a simulation. Its a complex assembly and I use automatically convert constraints to standard joint to save time. Now this is ok. However I like to delete some joints and change some welded groups but its not possible to delete or change anything. Why? Do I have to build everything manually if I like something different then what the automatically convertion makes?
Thanks.
Best Regards
Hans Pettersson
Im try to do a simulation. Its a complex assembly and I use automatically convert constraints to standard joint to save time. Now this is ok. However I like to delete some joints and change some welded groups but its not possible to delete or change anything. Why? Do I have to build everything manually if I like something different then what the automatically convertion makes?
Thanks.
Best Regards
Hans Pettersson