Easy5 hydraulic double-acting cylinder 1

[behnam jafari]

hello

I'm working on a project of designing a 4 double-acting hydraulic cylinder for a vehicle with easy5 .

Is it possible to model the hydraulic circuits including valves and accumulators and … as a full system ? and implementing it on a vehicle ?

has it been worked on before ? are there ready models so I won't have to start from scratch ?

thank you very much for this forum and good people participating … whatever questions I've had , have been fully answered .

 

[behnam jafari]

anybody ?????

 

[PNachtwey]

Is it possible to model the hydraulic circuits including valves and accumulators and … as a full system ? and implementing it on a vehicle ?

Yes! but I don't use Easy 5.

has it been worked on before ?

I do not know.

are there ready models so I won't have to start from scratch ?

I would start from scratch. I am very good a modeling hydraulic systems. I write my own from scratch.

https://deltamotion.com/peter/Mathcad/Mathcad - Hydraulic Cylinder.pdf

It is not hard to duplicate the cylinder simulation multiple times.






Peter Nachtwey
Delta Computer Systems

http://www.deltamotion.com

http://forum.deltamotion.com/

 

[behnam jafari]

can you help me with this hydraulic circuit .

I can't seem to figure out what is happening with the hydraulic models of the accumulators and valves and branches …

i really need this and i don't know where to begin for a full car model ...