Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Edge, Face load.

Status
Not open for further replies.

rserrano

Computer
Joined
Nov 23, 2008
Messages
7
Location
CO
I need to simulate a flexural test. In my model i defined a line load in the middle of the test part and 2 constrained lines at a small distance from the border.

In ansys Simulation i can load or constrain vertices, edges and faces. But i cannot create a new vertex in the middle of the face, or a new edge in the middle of the face, or a new face in the middle of the face. I am using the DesignModeler, but it just does not have the feature to do the job.

I have really tried a lot.

Could you please explain me how to do it? And could you point me to a good tutorial on Ansys 11.0?
Thanks.
 
I am sorry if i was not clear. I need to model a flexural strenght test. I have a tile with shape of a box of 0.40 m x 0.40 m x 0.01 m. In the middle of one of the surfaces of the tile i need to define a force in a line. How do i put a line, (in the DesignModeler), in the middle of a surface such that it appears in the Simulation application?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top