lorinczandras
Mechanical
- Jan 30, 2014
- 1
Hi there,
I get a dumb solid (aluminum cast part) wich I have to add 3 stiffeners in his cavity. I added the stiffeners as separate bodies, and I assembled them with the solid, so far, so good. Now I have to fillet all the newly created intersection edges, wich is causing me the trouble. I've tried all types of selection modes in the edge fillet options, but I did not managed to create all the fillets that I need, because the complexity of the cavity's surfaces, wich are filleted between them too.
Any good tips, please ?
I get a dumb solid (aluminum cast part) wich I have to add 3 stiffeners in his cavity. I added the stiffeners as separate bodies, and I assembled them with the solid, so far, so good. Now I have to fillet all the newly created intersection edges, wich is causing me the trouble. I've tried all types of selection modes in the edge fillet options, but I did not managed to create all the fillets that I need, because the complexity of the cavity's surfaces, wich are filleted between them too.
Any good tips, please ?