Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Edge flange around a corner

Thread starter DiegoLGraves
Start date Feb 19, 2010

Status: Not open for further replies.

Feb 19, 2010

DiegoLGraves

Mechanical

Some time ago someone posted a method of adding an edge flange around this type of corner. I don't remember if it was an actual sheet metal feature or just a work around. I'd appreciate some help creating the flange, or advice on best practice.

tia, Diego