Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

edit batch files automatically

Thread starter Mbyrne76
Start date Nov 29, 2010

Status: Not open for further replies.

Nov 29, 2010

Mbyrne76

Mechanical

Hi, I am new to ansys. I have a text batch file written. I can call it from matlab and get results. I want to then change a few parameters in the text file, run ansys from matlab again and loop. I don't know how to edit the correct lines in the text file using matlab. Is there some way to do this using ansys? People I have asked have mentioned include files, how do I use these?
Thank you