Editing a Driveworks Database...

[DerrickH]

I'm in the middle of creating a Driveworks Express Database and capturing info for a part, and I've just realized I didn't make a drawing of a part before I started the wizard. Is there anyway for me to go back in and attach a drawing if I complete the session without selecting one? I really would hate to have to go back and re-enter all of my dim/feature selections :-(



Derrick Hochgesang
Specials Project Engineer

 

[CorBlimeyLimey]

Can't answer your question, but you should be able to start a second session of SW to create the drawing without exiting DW Express ... providing you have sufficient system resources.

 

[DerrickH]

That worked, and I also found out that I can go in and modify my database at any time after the initial setup.

Derrick Hochgesang
Specials Project Engineer