Editing an existing hole.

[pgpelton]

After creating a general hole inside NX5, why can't I change the type of hole to a threaded hole? Is this something that our CAD administrators have locked down? Thanks in advance for any help.

 

[jerry1423]

I don't think you will be able to change the hole type until NX8.

 

[cubalibre000]

Yes, this limitation is cut off in NX8.
I suggest you install NX8 and you will see the light.
NX8 is a very good implementation in all modeling feature.

Thank you...

Using NX 7.0.1.7 MP3 and TC8.1