Electrical Routing and Deformable

[Dave W]

I have created a jumper hrn using NX electrical routing using a Netlist for the connections. However I would like to make this routing deformable. The connections and lengths remain the same, but at times during assembly it needs to be shown in a coiled position and a straight position routing to the same location.

Is it possible to use deformable with a B spline in Electrical Routing?
If so, what are steps and is there a tutorial or instruction that shows the steps.

 

[jerry1423]

There are a few videos pertaining to what you are looking for on YouTube.
I like the below guy, but certainly check out the others . . . search for NX deformable Routing.

https://www.youtube.com/watch?v=CRKkRvHb5DE

Jerry J.
UGV5-NX1899