Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Electrostatic analysis on WB. Volt loads.

Status
Not open for further replies.

jujumoi

Aerospace
Joined
May 26, 2004
Messages
20
Location
BR
Hello,
I always have used Ansys Classic, however, I had to change to workbench. I can run most of the analysis that I was used to run on Ansys Classic, the electrostactic analysis however, is not shown on environmental map. I could find only the Magnetostatics option (that's the closest environment to Emag that I could find). I would like to apply some VOLT boundary conditions. However this kind of load is not available on magnetostatics environment. I appreciate any help I could get.
Thanks.

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top