Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Elevations for pump and reservoir

Status
Not open for further replies.
bnard

bnard

Civil/Environmental
Oct 20, 2003
21
0
0
AU
Hi can anyone make clarifications on how to determine the elevations of pump and reservoir in watercad when the reservoir and pump house is underground?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Elevation is elevation - its all relative, based on your datum. WaterCad doesn't mind negative elevations (if that's what they end up being).
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

ntandomansa
  • Locked
  • Question
Using a Larger Combination Air Valve on a Smaller Pump Mains
Replies
4
Views
24
NW_Wash_Eng
NW_Wash_Eng
djcbgn
  • Locked
  • Question
Fluoride addition and pH
Replies
3
Views
33
EdStainless
EdStainless
geotechguy1
  • Question
Co-seismic fire ignition at WTP and WWTP
Replies
2
Views
41
bimr
bimr
NW_Wash_Eng
  • Locked
  • Question
Dynamic and Static Thrust Forces - What is considered "Problematic"
Replies
15
Views
27
NW_Wash_Eng
NW_Wash_Eng
TXPE_MED
  • Locked
  • Question
Horizontal and Vertical Conventional Pressure Tanks in same plant? 1
Replies
4
Views
33
1503-44
1503-44
Back
Top