Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

EN 1092-1 PN250 TONGUE GROOVE FLANGE GASKET

Status
Not open for further replies.

guanghui an

Mechanical
Nov 19, 2018
19
CN
for EN 1092-1 PN250 TONGUE GROOVE FLANGE, who know the EN gasket standard? In EN 1514-2, the PN is only up to PN160, the flange facing only limit to FF and RF. thanks!
 
Replies continue below

Recommended for you

Try en 1514-4

Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
 
If I mnay make a suggestion, use EN 1514-1, type TG. See para 4.3, and figure 1 type c).
1514-4 doesnt have TG type gaskets either, afaik.
 
@XL83NL:but EN 1514 only up to PN100, my flange is PN250, I want to use spiral wound gasket. thanks!
@littleinch: thanks!
 
for EN 1092-1 PN250 TONGUE GROOVE FLANGE, I cannot find EN spiral wound gasket standard, but I found DIN 2699, it is spiral wound gasket standard, it can be used in PN250.THANKS!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top