Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Encapsulating Transformers

Status
Not open for further replies.
Maxham1

Maxham1

Mechanical
Dec 22, 1999
50
We looking to encapsulate our transformers with windings around their E shaped cores. Is there a source that can help us a vacuum chamber that we can use when encapsulating the transformers? Each transformer is about 8 in X 8 in X 6 in in size. Basically when we're done with the encasulant process, we'll have brick slight larger than the initial dimensions shown above. We think we need a vacuum chamber so that we can remove all the air in the nooks and crannies formed by the winding/core assembly.

Thanks,

Dave
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom