Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Engineering Document Control

Status
Not open for further replies.

oakie

Industrial
Jan 27, 2001
9
I work for a small manufacturing company. I am looking for a procedure that controls Engineering Drawing creation, NC programming archiving and the such. Can anyone help me locate a standard for this?
 
Replies continue below

Recommended for you

For drawing creation and controls look to ASME Y14.100.

Also, this gives a good listing:

MadMango
"Probable impossibilities are to be preferred to improbable possibilities."
Have you read faq731-376 to make the best use of Eng-Tips Forums?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor