ENGRAVING ON A CURB SURFACE 1

[valdo]

Is it possible to do engraving on a part that has been created with a (curb)surface?
The Wrap Text command doesen't work only on cylindrical,conical,extruded or revolved face.
I have SW2004SP0

 

[SBaugh]

Wrap will work on some of those types of features. I just tried it on a cylindrical and extruded surface... No problem. Conical and revolved surfaces are not supported. SW04 SP4.1

Your going to have to follow your other thread. to get the workaround.

thread559-100606

Regards,

Scott Baugh, CSWP

http://www.3dvisiontech.com

http://www.scottjbaugh.com

If you are in the SW Forum Check out the FAQ section

To make the Best of Eng-Tips Forums FAQ731-376