Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Equal mesh for attaching/overlapping surfaces

Thread starter HuubTim
Start date Mar 18, 2015

Status: Not open for further replies.

Mar 18, 2015

HuubTim

Aerospace

Hi Guys,

I've been looking around how to mesh attaching/overlapping surfaces in order to have merging nodes.
I started to try one big surface, with a smaller surface inside. How do I get the smaller surface to have the same mesh as the larger surface for the area in which they overlap?

Thanks in advance!

Cheers