Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Equation Editor Volumes

Thread starter drawoh
Start date Jan 30, 2023

Status: Not open for further replies.

Jan 30, 2023

drawoh

Mechanical

I am trying to do some analysis within SolidWorks' equation editor. When I assign "SW-Volume" to a variable, I get the message "Potential circular reference", and it takes much fiddling around to make it update correctly. I am trying to convert a film wrapping into a length value for the BOM.

Is there a reliable way to call up volume within the equation editor?

--
JHG