Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Equation for bandwidth - correct units (cycles/sec or radians/sec)?

Status
Not open for further replies.

dculp1

Mechanical
May 16, 2006
75
Replies continue below

Recommended for you

It's irrelevant. Since the bandwidth of a circuit is based upon the point at which the amplitude has dropped to 70.7% of the max, you can call them whatever you want.

It's more convenient to put them in terms of Hz or radians (depending upon if you're dealing with straight frequency ranges, portions of the unit circle, etc.), but nothing says you have to... but your readers should understand what you mean, and keeping a standard helps.

Dan - Owner
Footwell%20Animation%20Tiny.gif
 
Classically, in analog linear circuits, capacitive reactance is given by j*ω*C, where ω is in radians. and ω = 2πf

TTFN
faq731-376
7ofakss

Need help writing a question or understanding a reply? forum1529


Of course I can. I can do anything. I can do absolutely anything. I'm an expert!
There is a homework forum hosted by engineering.com:
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor