Equipment for performing weld overlay on nozzles smaller than 3 inches

[FPPE]

Hi everyone,

Could you recommend a machine for performing internal weld overlay on nozzles with a diameter of 3 inches and below (e.g., a 2" LWN #300, which has an internal diameter of about 50 mm)?

We routinely perform weld overlay on heat exchangers, vessels, etc., but we do not have the appropriate equipment for small-diameter nozzles.

Thanks in advance for the answers!

 

[XL83NL]

Ive once seen a demo of Polysoude where they (for a customer in the EU, perhaps NL) had to internally clad some small dia large length (say 6 mtrs?) pipe. Dont know the exact dimensions, but you may give them a try.

 

[FPPE]

XL83NL, thank you very much, I'll contact them right away!