Hi everyone,
I am doing an EMAG analysis in ansys workbench 13.0, I am just trying to simulate a current in a copper conductor and obtaing the magnetic forces generated.
I created the air enclosure and specified as the open domain.
I specified the flux parallel conditions on the air, and also the current and voltage in the conductor.
I keep getting an "unknown error" in the solution, maybe its how I declared the open domain I dont know...
Also, I cannot simulate more than one conductor, ( conductors not in contact), I keep getting "unknown error".
The image is attached. PLEASE help...much appreciated.
I am doing an EMAG analysis in ansys workbench 13.0, I am just trying to simulate a current in a copper conductor and obtaing the magnetic forces generated.
I created the air enclosure and specified as the open domain.
I specified the flux parallel conditions on the air, and also the current and voltage in the conductor.
I keep getting an "unknown error" in the solution, maybe its how I declared the open domain I dont know...
Also, I cannot simulate more than one conductor, ( conductors not in contact), I keep getting "unknown error".
The image is attached. PLEASE help...much appreciated.