Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Error in Workbench: Element number 0 not defined

Status
Not open for further replies.
dwilly

dwilly

Mechanical
Jun 27, 2012
1
I am running a mechanical simulation in Workbench and get an error: "Element number 0 is not defined as part of the current model." This error appears right after ANSYS finishes processing all of the contact regions for the model. Any suggestions?
 
Status
Not open for further replies.

Similar threads

IJR
  • Locked
  • Question
Workbench 19: Submodelling (?) error
Replies
0
Views
151
IJR
IJR
struclearner
  • Locked
  • Question
Reaction Force Distribution in ANSYS Workbench!
Replies
0
Views
554
struclearner
struclearner
H
  • Question
how to apply triangular load on an area, in ANSYS Workbench static module
Replies
1
Views
2K
karachun
karachun
andradesilva
  • Locked
  • Question
How to change element type in ANSYS Workbench 2023 R1
Replies
1
Views
354
SPDL310
SPDL310
H
  • Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
1K
hmsilva
H

Part and Inventory Search

Sponsor

Back
Top Bottom