Error Message GAS Workbench 1

[anilsamuel007]

Hello to all,
I got one error message while on running a simulation problam
analysis: Simulation of stress distribution and displacement of sliding door of car
boundary conditions
2 pin and pockets gave smooth virtual part and 3 translational movements and 2 rotational(Y and Z) movements are arrested
2 Locks -gave smooth virtual part and the same restraints
totla 4 hinged parts when the door is closed
Load
A force of 9000 N is applied from inside to outside of the door(it ia type of Loadcase)
Error:
Factorized Matrix computation
Singularity detected in Rotation(pivot is too small)
Possible reasons: missing restraints or connection specifications
Display rotational vector to diagnostic the problam

How can I display the rotational vector in CATIA V5 GAS workbench??
Give me an advice please...
thanking you
Anil

 

[TibiX]

Hello anilsamuel007,

I think the problem might be caused by the rigid body motion.

CATIA V5 R21 – mold tool design engineer
plastics industry