error msg while using move feature command

[raindi]

Hi,
I am using nx8.5. I am working on project for a month. Recently for the last few days I am getting an error msg whenever I try to use move feature command and I am unable to use move features. the error msg reads like "An embedded measure can only be referenced once. Create another embedded measure or use another"
What does this mean? I am not sure even if this msg makes any sense as I am not trying to reference any measurement here.
Any urgent help would be appreciated.
Thank you.

 

[JohnRBaker]

Do you have ANY 'Measurement' features in your model? Are you 'Moving' or 'Copying' a Body?

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[raindi]

Hi,
want to move a feature up by 2mm. not trying to copy.
measurement features-I am not sure when you say this.
yes. I have used some simple measurements and then used that as an expression for something else.
Thanks,

 

[JohnRBaker]

I've tried a couple of scenarios which I thought would trigger an error like this but I couldn't. I think you'll have to contact GTAC and have them look at your model.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[raindi]

thank you