Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Error: "NO. of Multi-Base Curve is Zero" in SolidWorks Simulation

Thread starter gittenlucky
Start date Sep 11, 2012

Status: Not open for further replies.

Sep 11, 2012

gittenlucky

Aerospace

I am trying to do a simulation that is giving me a lot of problems. I have simplified my model down to a single piece and it is still not running for me. I have a single part that I apply a base excitation to and it give me an error "NO. of Multi-Base Curve is Zero". I have done some searches, but I can't find any information on this error. My base excitation is a sinusoid of 1" amplitude at 1 Hz for 1 second. Any help would be greatly appreciated.